Makers of holsters and sheaths who run the VacuForge™ 12 x 12 inch thermoform molding vacuum press can replace its heat sink board with this custom-fit piece.
Made to fit the #VP-1212 vacuum press, the board acts as a vacuum pass-through layer and gives you a work table surface for vacuum forming operations.
Both sides are usable, and it lies flat on the vacuum press bottom support table.
Specifications
- VacuForge™ heat sink replacement board
- Fits model Stk.# VP-1212
- Heat sink work table surface design
- Thickness 0.1875 inches
- Made of MDF
- Sold as a 1-pack
- Country of origin USA
